User Manual

Using your machine

Before you begin cleaning

• Always switch o and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing

and emptying the dirt container.

• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat, the

thermostat will automatically turn the vacuum cleaner o. If this happens, switch the vacuum cleaner o and unplug from

the electrical socket. Remove and empty the dirt container and also check the vacuum cleaner for blockages. Allow the

vacuum cleaner to cool for approximately 1 hour (if you have cleaned the lters please wait 24 hours for the lters to fully

dry before putting back into the vacuum).

• Pre-motor lters require cleaning at least every 3 months.

• If the vacuum cleaner is blocked, switch o and unplug before removing the blockage.

• When using the accessories always make sure the machine is stood in the upright position.

Extension tube

Remove the hose end

from the oorhead.

Remove the

extension tube.

Choose an accessory.

2-in-1 tool converts into:

A = Crevice Tool

B = Dusting Brush

Attach the accessory

to the hose end.

3-in-1 Tool converts into:

A = Crevice Tool

B = Upholstery Tool

C = Dusting Brush

Attach the accessory to the

extension tube.

Attaching the hose

Attach the hose to the

extension tube.

Using accessories

NOTE: The Turbotool, 2-in-1 Tool and 3-in-1 Tool can all be attached to the tube or directly to the hose.

NOTE: The brushbar will not spin until the machine is reclined.