User guide

7
V
ax Careline 0870 606 1248
clearing blockages / troubleshooting
8. Clearing Blockages
WARNING: To reduce the risk of injury from
moving parts, unplug before servicing.
Clearing Blockages from the TurboTool™ (U91-P3P /
U91-P4P only)
1. Turn the TurboTool™ over and slide off the locking-ring
(Fig.8/1).
2. Pivot lowering housing and remove clog (Fig.8/2).
3. To re-assemble, be sure that the tabs are engaged. Pivot
the lower housing closed. Slip the locking-ring into the
groove at the neck of the TurboTool™ to complete
reassembly (Fig.8/3).
9. Troubleshooting
WARNING: To reduce the risk of personal injury,
unplug the vacuum cleaner before performing
maintenance or troubleshooting checks.
PROBLEM: Vacuum cleaner won't run
Cause: Not properly plugged into electrical outlet.
Solution: Plug in firmly.
Cause: Blown fuse/tripped breaker.
Solution: Reset circuit breaker or replace fuse.
Cause: Thermal cut out.
Solution: Refer to page 3 for information.
PROBLEM: Cleaner won’t pick up/loss of suction.
Cause: Lower hose not connected properly.
Solution: Refer to page 4 for fitting information.
Cause: Dirt container not installed correctly, or full.
Solution: Review dirt container replacement.
Cause: Broken or worn belt.
Solution: Replace the belt.
Cause: Clogged filters.
Solution: Remove, clean and replace filters.
Cause: Nozzle / hose or hose inlet is clogged.
Solution: Remove nozzle/hose and obstruction.
PROBLEM: Dust escaping from the vacuum cleaner.
Cause: Dirt container full.
Solution: Empty dirt container.
Cause: Dirt container not installed correctly.
Solution: Review dirt container replacement.
Cause: Hose not installed properly.
Solution: Review vacuum cleaner assembly.
!
LOCKING RING
Fig.8/1
Fig.8/2
TABS
Fig.8/3
!
Vax U91-P3 & 4 Series User Guide.qxd:UG 2/4/09 18:06 Page 7