User guide

vax.co.uk

assembly

3. How to Assemble

IMPORTANT: Always unplug the vacuum cleaner

from the electrical outlet before assembling or

removing the accessories.

Tool required: Phillips screwdriver

1. Place the base of the cleaner so it is facing away from

you. Position the body so that the lower hose is on your

right hand side. Push the body down into place.

To secure the body in place insert two long screws

supplied into the back of the cleaner, through the hole

located above the hose guide (Fig.3/1).

2. With the cord clip on the handle facing you place it onto

the top of the body of the cleaner (Fig.3/2).

3. Push down firmly and line up the hole on the rear of the

handle. Insert lock piece into hole and screw into place

with the short screws (Fig.3/3).

4. Using the handle attach the main hose into the left

hand side of the cleaner. Press down firmly to secure in

place. The main hose can then be secured in the top and

side of the hose holder.

Push the dirt container lid firmly on top of the dirt

container and place it onto the cleaner. The canister lid will

snap into place in the body of the cleaner.

Attach the tools to the tool holder. The dusting brush fits

over a post at the back of the vacuum cleaner.

The crevice tool fits into the extension wand. The

extension wand is located on the right hand side (Fig.3/4).

5. Store the TurboTool™ in the caddy on the handle

(U91-P3P / U91-P4P only) (Fig.3/5).

Phillips screwdriver required

Fig.3/1

Fig.3/2

Fig.3/3

Fig.3/5

Fig.3/4

Back of

unit

Vax U91-P3 & 4 Series User Guide.qxd:UG 2/4/09 18:06 Page 4