User guide

vax.co.uk
10
general maintenance
8. General maintenance
WARNING: to reduce risk of injury from moving
parts - unplug before servicing.
Debris removal/hose
Debris removal/nozzle guard
• Check to see if dirt container is full; empty if needed.
• Plug cleaner in and check to see if there is any suction
at end of hose. If there is no suction at the end of hose,
follow these steps:
1. Unwrap hose from caddy. Twist and unlock to remove
clogs. Clean out hose with a broom handle. Check access
door on back of cleaner (near hose end). Remove the
seven (7) screws and check for obstruction (Fig.8/1).
2. Remove dirt container (Pg. 6) and check dirt container
inlet located on cleaner (Fig.8/1).
3. Remove nozzle guard (see Fig.8/2) by removing the
three (3) screws. Remove obstructions (Refer to Page 8
for belt and brushbar removal and replacement).
WARNING: To reduce the risk of injury from
moving parts, unplug before servicing.
Clearing Blockages from the TurboTool
1. Turn the TurboTool over and slide off the O-ring
(Fig.8/1).
2. Pivot lowering housing and remove clog (Fig.8/2).
3. To re-assemble, be sure that the tabs are engaged. Pivot
the lower housing closed. Slip the O-ring into the groove at
the neck of the TurboTool to complete reassumbly
(Fig.8/3).
Fig.8/1
Fig.8/2
!
‘O’ RING
Fig.8/1
Fig.8/2
TABS
Fig.8/3
!
U90-MVX-P Mach VX Pet User Guide.qxd:v1 21/12/09 17:38 Page 10