User guide

Taking care of your machine
Changing the belt
Using a crosshead
screwdriver, remove 3
screws from the belt cover
on the side of the oorhead.
Pull to remove the
brushbar location
plate. Remove belt.
Slide o the
locking ring.
Line up the tabs on front of
housing and re-t.
Slide locking ring into
groove to secure.
Locking ring
Pull to remove the belt cover.
Clean any debris from
spindle. Place new belt onto
spindle, lining up teeth on
belt over and onto cog.
Lift and separate the housing.
Using a pair of scissors remove
any threads or hair caught around
the brushbar.
Removing blockages from the TurboTool (some models only)