User guide

TIP
Cleaning the pre-motor lter and shroud
Emptying the dirt container
Press the dirt container
release button, pull to
remove the dirt container.
Hold dirt container over a bin.
Press the dirt release clip,
allowing dirt/debris to fall out.
Wash the lter under
running water (40 degrees
max) Leave to dry for 24
hours or until fully dry
before placing back in
the vacuum cleaner.
Turn the dirt container
lid anti-clockwise.
Pull the lter tab to
remove the lter.
Lift the shroud from
the dirt container.
Tap the shroud over a bin
to release dirt/debris.
Lift the dirt container
lid to remove.
Tap the lter over a bin to
remove any dirt/debris.
24hr
MAX
40˚C
!
MAX
40˚C
TAP
T
A
P
Don’t over ll the dirt container
to avoid blocking the air ow
through the vacuum cleaner.
IMPORTANT: The motor is equipped with a thermal cut-out. If for any reason
the machine should overheat, the thermostat will automatically turn the machine
o. Switch o and unplug the vacuum cleaner. Check the machine for blockages
and clean the lters . Wash the lters with warm water (40°C max) and leave
for 24 hours or until fully dry before replacing into the machine. Filters require
cleaning at least every 3-6 months (depending on the level of use).
Don’t use your vacuum cleaner without all of the lters in place.
Taking care of your machine