User guide

• The vacuum cleaner is making a whistling noise, please remove the
dirt container open the bottom and clean the seals.
Replace the dirt container and retry
• If there is air sucking noise from the top of the dirt container, this
would indicate a blockage in the machine Go to ‘Why won’t the
vacuum cleaner pick up above’
SolutionProblem
Warning: To reduce the risk of personal injury, unplug the vacuum cleaner before performing maintenance
/troubleshooting checks.
What to do if it goes wrong Getting in touch
• The plug may not be fully pushed into the electrical socket
• Check the fuse in the plug if this needs replacing, always
replace with a 13amp fuse
• The motor thermostat may have tripped. If this has happened,
unplug the vacuum cleaner. Remove and empty the dirt container and
check the hose for blockages Clean the lters and allow the vacuum
cleaner to cool for approximately 1 hour (if you have washed the lters
you will need to wait 24 hours for the lters to fully dry before putting
them back into the vacuum cleaner)
Why won’t the vacuum
cleaner turn on?
What if my vacuum
cleaner is making an
excessive noise?
• The brushbar may be jammed. If this happens then the machine
needs to be switched o immediately to avoid damage. To remove
debris from brushbar refer to page.
• The belt might not turn if it is broken. To check the belt, go to
the‘Changing the belt’ page.
My brushbar
isn’t turning?
• There may be a blockage in the hose. Please remove the hose from the
vacuum cleaner, check and clear any blockages
•
Empty the dirt container and clean lters. Go to the
Let’s maintain section page *’
• The brushbar may not be turning.
Go to ‘My brushbar isn’t turning?’ below
• If the accessory/tool will not pick up, check and clear
any blockages
Why won’t the vacuum
cleaner pick up?
• Check the ‘This pack contains’ panel on the box to make sure
the part is included with your machine.
There is an accessory
missing?