User guide

Assembling your vacuum cleaner
Lift handle up and click
into place.
Slide 2 in 1 Dusting Brush onto
dust brush holder with brushes
facing outwards.
Line up latch on accessory hose,
push until clicks into place.
Line up turbo tool brushes into
turbo tool holder, push into place
until it clicks (some models only).
Push accessory hose into
hose to machine connector.
Push extension tube and
crevice onto holder.
Before you begin cleaning
WARNING: Always switch o the vacuum cleaner before connecting
or disconnecting the hose/attachments or removing and emptying the
dirt container.
IMPORTANT: The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat
the thermostat will automatically turn the vacuum cleaner o. If this happens switch the vacuum cleaner o and unplug
from electrical socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the
vacuum cleaner to cool for approximately 1 hour (if you have cleaned the lters please wait 24 hours for the lters to fully
dry before putting back into the machine).
Filters require cleaning at least every 3-6 months. If the vacuum cleaner is blocked, switch o and unplug before removing
the blockage.
When the vacuum cleaner is stood in the upright position, or when using the hose and tools the brush bar height adjuster
must be set to the highest setting.
Getting to know your machine Getting started
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Extension tube
and crevice
Handle release button
Dust brush holder
(some models only)
Handle
Turbo tool holder
(some models only)
Carry handle
Dirt container
release button
Separator
Dirt container lid
Dirt container
HEPA pre-motor lter
(hidden)
Dirt release clip
Upper release
cord hook
Hose to machine
connector
Height adjuster dial
Name Flair
Voltage 220-240V-50Hz
Wattage 850 Air Watts
Cord length 8m
Weight 7.5kg
Technical Specication
Subject to technical change without notice.
Filter Kit (Type 110)
1-1-134394-00
Belt Kit Type 25
1-1-134411 -00
Turbo Tool Type 6*
1-1-134419-00
Crevice Tool (Type 16)
1-1-134427-00
Dusting Brush (Type 10)
1-1-134426-00
Pro Cleaning kit
(1-1-133326-00)
Accessories & Consumables
* Selected models only.
To purchase consumables and accessories, please visit vax.co.uk
Hose connector
Hose inlet
On/o button
U86-FN_Pe_FlairEasy-Store_UG_[J2543]_Amd_01.07.14.indd 6-7 01/07/2014 14:14