User guide

TIP
Always make sure the shroud
is fully dry and correctly
tted before replacing back
into the machine.
Grasp tab on lter and
pull to remove.
Turn the dirt container
lid anti-clockwise and lift
to remove.
Cleaning the shroud
Cleaning the post motor lter
Press button on post motor
lter cover and remove.
Lift the shroud from the dirt
container and tap over a bin
to remove dirt and debris.
Tap the post motor lter
over a bin to remove any
dirt and debris and replace
it into the machine.
Pull the post motor lter
from the machine.
Wash the shroud under running water (Max
40’C) and leave to fully dry for at least 24 hours
before replacing back into the dirt container.
tap
24hr
40
o
C max
!
Switch o your vacuum
cleaner at the main socket.
Using a pair of scissors,
cut any hair or debris free
from around the brushbar.
Remove the rubber ring. Push both buttons to open
the turbo tool.
Using a pair of scissors,
cut any hair or debris free
from around the brushes.
Switch o and unplug your
vacuum cleaner. Recline
the vacuum and lie it on its
front, remove 5 screws to
release brushbar cover.
Lift the brushbar out of the
oor head and remove the
drive belt.
Remove the brushbar cover
and push the oor head
into reclined position.
Remove the drive belt and
any debris from the spindle.
Loop new drive belt around
the spindle rst and then onto
the brushbar. Insert the
brushbar back into oor head
and replace the brushbar cover,
insert 5 screws to secure.
Removing debris from the brushbar
Removing blockages from the TurboTool
Taking care of your machine Let’s talk technical
Grasp the centre of the
shroud and pull
to remove.
Changing the belt
U86-PF-P_Performance_Floors&All_UG_[J2214]_Comp_31.12.13.indd 10-11 31/12/2013 14:22