User Manual

Using your machine
Before you begin cleaning
• Always switch o and unplug the vacuum cleaner before connecting or disconnecting the hose/attachments, or removing
and emptying the dirt container.
• The vacuum cleaner is equipped with a thermal cut-out. If for any reason the vacuum cleaner does overheat the thermostat
will automatically turn the vacuum cleaner o. If this happens, switch the vacuum cleaner o and unplug from electrical
socket. Remove and empty the dirt container also check the vacuum cleaner for blockages. Allow the vacuum cleaner to
cool for approximately 1 hour (if you have cleaned the lters please wait 24 hours for the lters to fully dry before putting
back into the vacuum).
• Pre-motor lters require cleaning at least every 3 months.
• If the vacuum cleaner is blocked, switch o and unplug before removing the blockage.
• When using the accessories always make sure the brushbar is switched to the o position.
NOTE: When the vacuum cleaner is stood in the upright position the brushbar will automatically stop.
Telescopic extension tube
Remove hose end
from the oorhead.
Remove telescopic
extension tube.
Choose an accessory.
(Note: Some tools will
require the tool connector
when tting).
Attach accessory
to hose end.
3-in-1 tool converts into:
A = Crevice Tool
B = Upholstery Tool
C = Dusting Brush
A
B
C
Attach accessory to
telescopic extension tube.
Attaching the hose
Attach hose to telescopic
extension tube.
Using accessories
NOTE: The crevice tool, dusting brush and upholstery tool can all be attached to the telescopic tube or directly to the hose.
Accessories may vary.