User`s guide

SETUP
(SETUP)
Sets hardware characteristics for the terminal, printer, and system clock.
Format
SETUP [hardware] mode[,mode...]
Parameters
hardware
Specifies one of the following:
• TERMINAL or TT (the default for printer and terminal modes)
If you do not specify a hardware parameter, SETUP assumes TERMINAL
for all modes except CLOCK modes. For CLOCK modes, SETUP assumes
CLOCK.
• PRINTER or LP or LS
The PRINTER mode is the only mode in which you must specify the hardware
parameter, which in this case is printer.
If you specify PRINTER, SETUP looks first for device LP and, if not found,
then looks for device LS to send the mode to your printer. The Professional
300 series processors support PRINTER modes for only the LA50, LA100,
and LQP02 printers.
Some modes or printer features are incompatible with some arguments.
Check your hard-copy terminal or printer user guide. See also Appendix B
for a summary listing of the modes that you can use with different printers.
• CLOCK (the default for clock modes)
CLOCK sets modes in your system clock. You need not specify CLOCK to set
clock modes in your system clock.
mode
Specifies a hardware feature. Table 3 lists all the modes you can specify with
SETUP.
RT–11 Command Descriptions 279