User guide

Using your machine
CAUTION: Always allow the steamer to fully cool down before removing the microbre pad.
The blue light will illuminate
to show power on and
steamer is heating.
Refreshing carpets
IMPORTANT: When using on carpets, always make sure the microbre cleaning pad covers the oor head entirely
before using the carpet glider. Only use the carpet glider when refreshing carpets
Place the microbre pad on
the oor white side facing
up. Place steamer onto pad
making sure the entire pad
covers the oor head.
With microbre pad
attached, place steamer
into the carpet glider.
The carpet glider should
only be used when
refreshing carpets.
The green light will
illuminate to show the
steamer is ready to use.
The green light will go
o when the steamer is
re-heating.
Plug into mains and press
the power button to
switch on.
Place your foot onto the
oor head and pull handle
backwards to recline.
To produce steam squeeze
the trigger in short bursts.
Don’t hold the trigger
continuously to prevent
over wetting carpets.
Move the steamer slowly
backwards and forwards
across the carpet paying
particular attention to high
trac areas. Squeeze/
release trigger as required.
Lift steamer o
carpet glider.
Hold corner of pad down
with your foot and lift
steamer to remove.