Operation Manual

(*NOTE: 50ml detergent plus
250ml water to 1 clean water tank).
Before you begin cleaning
Filling detergent tank
Filling clean water tank
vax.co.uk
5
Remove the detergent
tank from back of unit.
Twist the cap slightly
anti-clockwise to remove.
Pour 50ml of Vax detergent
and 250ml of water into the
detergent tank and replace
the tank cap. Tighten by
twisting clockwise.*
Slide detergent tank down
and snap into place.
IMPORTANT: Do not use hot or boiling water to fill clean water tank. Do not overfill the water tank.
IMPORTANT: Do not mix Vax detergent with any other cleaning detergent.
This product can be used with and without detergent.
WARNING: To reduce the risk of personal injury, unplug the stick steam cleaner when filling the unit.
Remove the clean
water tank at the front
of the unit.
Twist the cap slightly
anti-clockwise to remove.
Fill the tank with max
500ml of water and replace
the water cap. Tighten by
twisting clockwise.
Replace the clean water tank,
clicking into place making sure
the hard water filter is in
place. Do not use steamer
without tanks in place
IMPORTANT: Your detergent control dial will be set to ‘tough stains’ when you remove your steamer from the box.
If you do not want to use detergent on your flooring, this must be rotated to ‘steam/refreshes carpets only’ position.
Always test on an inconspicuous area of flooring first before using detergent.
NOTE: Do
not over fill.
NOTE: Do
not over fill.
IMPORTANT: Please refer to floor manufacturer’s care recommendations before use and test the steamer on a
discrete area of flooring to begin with.
Operation