V-028PX User Guide v2.qxd:V-028PX User Guide 14/3/08 10:53 Page 1 Vax careline 0870 6061248 Carpet washer Vax model number: V-028PX ULTRA instruction manual Extra SOLUTION www.vax.co.uk Please read carefully before using this cleaner. Always fully extend the mains cable before use. Retain for future reference.
V-028PX User Guide v2.qxd:V-028PX User Guide 14/3/08 10:53 Page 2 www.vax.co.uk 1. Diagram V-028PX 1 20 19 2 10 18 11 3 12 13 4 17 5 9 16 8 14 15 7 6 22 ULTRA 23 27 21 24 SOLUTION Fig.
V-028PX User Guide v2.qxd:V-028PX User Guide 14/3/08 10:53 Page 3 Vax Careline 0870 606 1248 2. Safety Information FOR HOUSEHOLD USE ONLY. When using the vacuum cleaner, basic safety precautions should always be observed, including the following: 1. 21. Using improper voltage may result in damage to the motor and possible injury to the user. The correct voltage is listed on the rating label. 22. A hazard may occur if the carpet washer runs over the power supply cord.
V-028PX User Guide v2.qxd:V-028PX User Guide 14/3/08 10:53 Page 4 www.vax.co.uk 3. Assembly Putting your cleaner together Stand base in upright position. Push mid-section onto base by aligning tabs on inside of mid-section with the pockets on the base (Fig.3/1) mid-section Fig.3/4 tabs back view Caddy Assembly pockets Align tool caddy with screw holes on mid-section and base (Fig.3/5). base Fig.3/1 cord Insert 4 lower handle/tool caddy screws and tighten until secure (Fig.3/2). Fig.
V-028PX User Guide v2.qxd:V-028PX User Guide 14/3/08 10:53 Page 5 Vax Careline 0870 606 1248 Cord Storage hose clips Wrap cord around upper and lower cord wraps (Fig.3/7). Clip plug to cord to secure for storage. A upper cord wrap lower cord wrap with quick cord release B Fig.3/10 Continue wrapping hose clockwise, aligning hose into groove on the bottom hose clip (Fig.3/11). Fig.
V-028PX User Guide v2.qxd:V-028PX User Guide 14/3/08 10:53 Page 6 www.vax.co.uk 4. Operation Preparing the Carpet ! IMPORTANT: Do not use the carpet washer as a dry vacuum. How to Operate Grasp clean water tank under handle while pressing clean water tank latch. Tilt clean water tank away from cleaner and remove (Fig.4/1). 1. Vacuum carpet thoroughly. Use a vacuum cleaner with a revolving brushbar for best results. clean water tank latch 2. Remove as much furniture from the room as possible.
V-028PX User Guide v2.qxd:V-028PX User Guide 14/3/08 10:53 Page 7 Vax Careline 0870 606 1248 Carpet Cleaning Fill remainder of clean water tank with warm (max 50ºC) tap water. Replace cap (Fig.4/4). Fig.4/7 Fig.4/4 Place bottom of clean water tank into carpet washer and rotate top into position until the clean water tank. Latch snaps into place (Fig.4/5). Whilst depressing solution spray trigger, push carpet washer in a forwards motion.
V-028PX User Guide v2.qxd:V-028PX User Guide 14/3/08 10:53 Page 8 www.vax.co.uk Remove the dirty water tank door from the top of the dirty water tank (Fig.4/10). ! IMPORTANT: For best cleaning results use steady, moderate, forward and backward motion. Make sure upholstery is dry before use. NOTE: If the dirty water tank door is not replaced, there will be no suction through the nozzle and the unit will not operate properly. Fig.
V-028PX User Guide v2.qxd:V-028PX User Guide 14/3/08 10:53 Page 9 Vax Careline 0870 606 1248 Remove filter from rear of dirty water tank lid (Fig.4/18) latch handle Fig.4/14 Grasp handle and pull tank out of base (Fig.4/15). Fig.4/18 Rinse dirty water tank and filter with warm tap water. Wipe and let dry thoroughly before storing to prevent mildew from forming (Fig.4/19). Fig.4/15 Remove dirty water tank lid (Fig.4/16). Fig.4/19 NOTE: Do not use any chemicals when cleaning.
V-028PX User Guide v2.qxd:V-028PX User Guide 14/3/08 10:53 Page 10 www.vax.co.uk Push handle down until it latches (Fig.4/21). NOTE: Do not store cleaner with solution in reservoir or dirty water in dirty water tank. Mineral deposits and mildew can form which will affect the performance of the carpet washer. Fig.4/21 5. Maintenance Transporting & storing carpet washer Put handle in upright locked position (Fig.5/1). Fig.5/1 Turn unit off. Store cord and above floor cleaning attachments if used.
V-028PX User Guide v2.qxd:V-028PX User Guide 14/3/08 10:53 Page 11 Vax Careline 0870 606 1248 6. Troubleshooting ! 7. UK Service & Help WARNING: To reduce the risk of personal injury, unplug the vacuum cleaner before performing maintenance or troubleshooting checks. PROBLEM: The cleaner won't run. Cause: Not properly plugged into electrical outlet. Solution: Plug in firmly. Cause: No electricity in electrical outlet. Solution: Check fuse or breaker. Cause: ON/off switch not turned on.
V-028PX User Guide v2.qxd:V-028PX User Guide 14/3/08 10:53 Page 12 --- EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the Vax V-028PX is manufactured in compliance with the following Directives: Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
