User guide

Stand the base in the upright
position. Assemble the mid section
onto the base, taking care not to
trap internal mains wire.
Insert the two nuts into the
recesses located on the left and
right sides of the base.
While holding the nuts in place,
insert the two medium length
screws through the front of
the mid section and tighten.
Slide upper handle down onto the
unit. Insert nut into the recess in the
back of the upper handle. While
holding the nut in place, insert the
long screw through the front of the
upper handle and tighten.
Run the mains wire above the
upper cord hook and secure with
the cord clip.
Putting your cleaner together Phillips screwdriver required
1
2
3
4