User guide

Cleaner won’t run
Vacuum won’t pick up/
loss of suction
Dust escaping from the
Vacuum
Cleaner won’t dispense
solution
• Power cord not firmly pushed into a
mains socket.
• Blown house fuse or tripped circuit breaker.
• Dirty water tank is full.
• Dirty water tank is not installed properly.
• Solution reservoir not installed correctly.
• Solution reservoir not installed correctly.
• Solution tank empty.
• Plug cord in firmly.
• Check fuse/breaker. Replace fuse or
reset breaker.
• Refer to page 15 for fitting information.
• See ‘Emptying the dirty water tank’.
• Replace the belt.
• Replace the brush roll.
• Remove obstruction.
• Refer “Important” notes on page 13.
• Empty dirty water tank.
• Refer to page 15 for fitting information.
• See ‘How to operate your cleaner’.
• See ‘How to operate your cleaner’.
• Fill tank see pages 8 and 9.
Troubleshooting
Problem Possible Cause Possible Solution
• Dirty water tank is not installed correctly.
• Dirty water tank is full.
• Broken or worn belt.
• Brush roll is worn.
• Nozzle/dirt passage is clogged.
• Float prematurely activated.