User guide

15
Grasp the handle and hook the front of
the dirty water cleaner into the base,
making sure that the front of the dirty
water tank is resting on the base.
The dirty water tank has three tabs on the
underside which MUST latch on to the
underside of the base of the cleaner. The
base must be lifted so that the nozzle is
flush with the base of the cleaner.
Failure to install the dirty water tank
correctly will result in poor dirty water
pick up.
While making sure the dirty water tank is
resting on the base, place the rear of the
tank into the base of the cleaner, push
down on the handle until it latches.
Empty and rinse clean the water tank
after use.
Lift the front of the carpet cleaner
base off the carpet with one hand.
Replacing the dirt water tank
1
2
3