User guide

Plug the cord into a mains electricity
socket. Turn the power and brush bar
switches on.
The switches are located on the front
of the cleaner, above the solution
reservoir.
The power switch controls the
vacuum motor and pump. The brush
switch only turns the rotating brush
bar on and off when the power switch
is on.
Press on the handle release pedal
and pull the cleaner back into a
reclined position.
While pressing the solution release
trigger, pull the cleaner in a backward
motion. Release the trigger and push
forward over the same path to
remove the dirty water and solution
from the carpet. Repeat if necessary.
For best results use a smooth steady
action - keeping the nozzle flat
against the carpet. When the dirty
water reaches the max fill line on
the dirty water tank, empty the tank.
7
8
9
10
How to operate your cleaner
Important: Never leave the cleaner unattended with the power on.
Vacuum carpets thoroughly with dry vacuum cleaner before washing.