Installation guide

Figure 3–16 shows the multi-host I/O panel. At the I/O bulkhead of the
host system whose KFMSA node ID you need to change, turn the KFMSA
node ID select knob to the new ID number. The I/O panel’s ID input has
priority over any software changes. If you have access to a multi-host I/O
panel, change the second host’s KFMSA node ID to 6 and the third host ID
to 5. Usually, both buses for each KFMSA are set to the same node ID.
If your system does not have a multi-host I/O panel, change the node ID
using EVCXF (see Section 3.6.5).
FOR MORE INFORMATION
Primary reference: KFMSA Module Installation and User Manual
Secondary reference: SF2xx Storage Array Installation Guide
Connecting to a DSSI Subsystem 3–39