Installation guide

The autosizer program EVSBA takes several minutes to execute, but will
save you time as you proceed with other tests.
Run EVSBA to identify the hardware on your system and build a
database for VAX/DS. The autosizer eliminates the need for you to type
in the name and characteristics of the hardware you intend to test
under VAX/DS with level 3 diagnostic programs. A run of EVSBA can
require 2 to 3 minutes. See Example 3–2.
Select all devices.
You can issueaSHOWSELECT command. Here, apartiallisting shows
what information is reported on KFMSA devices. This system has two
KFMSAs attached, with RF devices configured on the first KFMSA.
In this example, the second KFMSA is empty. You would encounter
this example when a KFMSA has not been cabled to ISEs or problems
exist on the bus. In this example the cables were loose on these buses;
the operator reseated the cables and ran the software again. All ISEs
were shown.
Connecting to a DSSI Subsystem 3–35