Installation guide

3.6.2 Example: Run the Autosizer

Example 3–2 shows running the autosizer program EVSBA.

Certain conditions cause the generation of an unexpected

trap or interrupt. The method shown avoids these

conditions.

Example 3–2: Running the Autosizer

DS> RUN EVSBA

*********************************************************************

1981, 1989, 1990, 1991.

*********************************************************************

.. Program: EVSBA - AUTOSIZER level 3, revision 7.65, 3 tests

at 00:00:31.51.

.. End of run, 0 errors detected, pass count is 1,

time is 31-DEC-1991 00:03:03.76

DS> SEL ALL

! Program attaches all devices.

DS> SHOW SELECT ! Program lists all attached devices.

_PAA0 KFMSA HUB 61880000

XMI Node Number (1 to E)=00000001(X) PORT Number (1,2)=00000001(X)

_DIA1 RF72 _PAA0 61880000 DSSI NODE (0 - 7)=1.

_DIA2 RF72 _PAA0 61880000 DSSI NODE (0 - 7)=2.

_DIA3 RF72 _PAA0 61880000 DSSI NODE (0 - 7)=3.

_DIA4 RF72 _PAA0 61880000 DSSI NODE (0 - 7)=4.

_PAB0 KFMSA HUB 61880000

XMI Node Number (1 to E)=00000001(X) PORT Number (1,2)=00000002(X)

_DIA1 RF72 _PAB0 61880000 DSSI NODE (0 - 7)=1.

_DIA2 RF72 _PAB0 61880000 DSSI NODE (0 - 7)=2.

_DIA3 RF72 _PAB0 61880000 DSSI NODE (0 - 7)=3.

_DIA4 RF72 _PAB0 61880000 DSSI NODE (0 - 7)=4.

_PAC0 KFMSA HUB 61900000

XMI Node Number (1 to E)=00000002(X) PORT Number (1,2)=00000001(X)

_PAD0 KFMSA HUB 61900000

XMI Node Number (1 to E)=00000002(X) PORT Number (1,2)=00000002(X)

3–34 VAX 6000 Series Installation Guide