Installation guide

To conﬁgure a DSSI subsystem, start with a conﬁguration sheet.

Appendix D has sheets for single- and dual-host conﬁgurations. Record

all system information for each ISE as you cable and set the node IDs.

To conﬁgure a DSSI VAXcluster, follow this procedure:

1. If you have a dual- or tri-host system, change the node ID of the KFMSA

on the second and third host systems.

2. Cable the SF2xx I/O bulkhead to a speciﬁc KFMSA (bus 1 or 2).

3. If required, set the ISE node ID using the operator control panel on

the SF7x enclosure. The IDs should be factory set to acceptable values

already.

4. Run the VAX Diagnostic Supervisor.

5. Run the autosizer.

6. Run the EVCXF diagnostic to conﬁrm all node information.

FOR MORE INFORMATION

Primary reference: KFMSA Module Installation and User Manual

Secondary reference: SF2xx Storage Array Installation Guide

Connecting to a DSSI Subsystem 3–25