Installation guide

1. Unpack the console terminal. The console terminal signal cable is
shipped in the loose piece box. The cable number is BC22D–25. If
you are installing a remote services console, see Appendix A.
2. Unpack the printer. Connect the BC16E–10 signal cable to the printer
and to the console terminal. Plug in the printer.
3. Attach the BC22D–25 signal cable to the console terminal and to the
system I/O panel (see Figure 2–6). Plug in the console terminal.
4. Set the following terminal characteristics. See the console terminal
user’s guide for more information.
NOTE: The system cabinet’s baud rate is factory set at 1200.
• 8 data bits, 1 stop bit
• No parity
Unpacking 2–13