Installation guide

1. Using a 9/16 inch or adjustable wrench, lower and adjust the leveler
feet. (A shipping bracket can also be used to lower the leveler feet. The
bracket cutout and leveler feet hexnuts are the same size.)
2. Using a bubble level, check to see if the cabinet is properly leveled.
3. Unlock and open the front and rear doors (see Figure 2–5).
4. At the front of the cabinet, visually check to see that all processor,
memory, and I/O modules are seated properly.
5. At the rear of the cabinet, check I/O bulkhead connections for tight
connections. CIXCD and DEMFA connections use active headers and
their connections may have loosened in shipment. Tighten as needed.
Figure 2–5: Cabinet Door Lock and Key
msb-0485-90
KEY OR
HEX WRENCH
KEY
HOLE
Unpacking 2–11