Installation guide

KDM70 adapter, 5–6
KFMSA adapter, 3–5, 3–8, 3–10 to
3–11
bus locations, 3–27
cabling, 3–27
LEDs, 3–10
node IDs, 3–28 to 3–29, 3–38 to
3–41
on-board termination, 3–11
options, 3–23
self-test, 3–10
KLESI-B adapter, 5–5
L
LARS form, 2–3
LEDs after self-test, 7–3
M
Mixed-host, 3–7, 3–20 to 3–21
Module handling, B–3
Multiprocessor tests, 8–20
N
Network options, 3–4
Node ID, 3–9, 3–38 to 3–41
changing value, 3–29
Node name, 3–8
O
Operating the control panel, 6–10
to 6–17
ISE operator control panels, 3–9
P
Power modules, 1–11
Power plugs and receptacles, 1–12
Power requirements, 1–10
Power-up procedure, 6–1 to 6–8
and verification, 8–7
checking power at site, 6–7
checking the 50 Hz transformer,
6–4
Power-up procedure (Cont.)
enabling the system, 7–2
H405-E indicator lights, 6–8
H7206-B diagnostic LEDs, 6–8
Processor modules
handling, B–3
inserting into card cage, B–5
Q
Quiet slot DELTA time, 4–10
R
Remote services console, A–1
RF disk drives, 3–17
ROM-based diagnostic for tape drive,
8–10
Running UETP, 8–26
Running VAX/DS standalone, 3–32
S
SA600 disk cabinet, 5–6
SDI cables, 5–7
Self-test, 7–3, 8–6
and module indicator lights, 7–3
display, 7–4
explanation of sample
configuration, 7–5
line
ETF, 8–7
STF, 8–7
XBI, 7–6 to 7–7, 8–7
sample results, 7–4 to 7–5
VAXBI module test results, 7–7
SF2xx, 3–16 to 3–17
components, 3–17
configuration, 3–17
definition, 3–9
levels, 3–17
upgrading, 3–17
SF7x, 3–14 to 3–15
configuration, 3–15
definition, 3–9
Index–3