Installation guide

8.7 Run the Autosizer and Multiprocessor Tests
Model 500 and 600 systems and single-processor systems do
not need this step; for these models, go to Section 8.8. First
run the standalone autosizer (EVSBA), which attaches all
processors for the VAX Diagnostic Supervisor.
Example 8–6: Running the Multiprocessor Diagnostic
DS> RUN EVSBA
.. Program: EVSBA - AUTOSIZER level 3 X6.6, revision 6.6, 3 tests,
at 00:25:05.10.
.. End of run, 0 errors detected, pass count is 1,
time is 31-DEC-1991 00:27:42.34
DS> SET TRACE
DS> SELECT ALL
DS> RUN ERKMP
.. Program: ERKMP -- KA64A MP Exerciser, revision 1.0, 10 tests,
at 00:29:19.81.
Testing: __KA0__KA1
Booting Secondary Processor #02
Test 1: Memory Interlock Test
Test 2: Interprocessor Interrupt Test
Test 3: Write Error Interrupt Test
Test 4: Cache Invalidate Test
Test 5: XMI Bus Arbitration Test
Test 6: XMI Bus Arbiter Collision Test
Test 7: XMI Lockout Test
Only 2 CPU(s) selected for testing...
XMI LOCKOUT can only be verified with 6 CPUs selected.
continuing...
Test 8: Cache Coherency Test
Test 9: XMI Suppress Test
Only 2 CPU(s) selected for testing...
XMI SUPPRESS can only be verified with 4 or more CPUs selected.
continuing...
Test 10: Multiprocessor Exerciser
.. End of run, 0 errors detected, pass count is 1,
time is 31-DEC-1991 00:33:49.77
DS> EXIT
>>>
8–20 VAX 6000 Series Installation Guide