Installation guide

Enter 1 to select Find Services. Software locates available Ethernet
services and displays them.
If you are certain of the diagnostic CD’s name and revision number,
you could choose 2 here (Enter Known Service Name. The system will
prompt you for the service name (diagnostic CD volume label), and then
boot. However, to display all available services, choose 1 and proceed
with the following steps.
System prints out services loaded in the CD servers. One of the services
will show the diagnostic CD-ROM you loaded in the CD drive.
This example shows two CD servers: one server with the name of ESS_
0800XXCGH321 with Ethernet address 08-00-2B-16-04-D4 has service
#3 with the diagnostic tape 6000_DIAG_A, at revision A; server with
name INFO1 (a name set at InfoServer installation) with Ethernet
address 08-00-2B-18-A9-75 has service #4 with the diagnostic tape
CONS_DIAG_B, at revision B.
Enter the number of the service, which is the diagnostic CD-ROM. If
more than one copy of the "VAX 6000 CMPLT DIAG CD-ROM" is shown
as loaded in the CD drives, choose the drive where the revision letter
is the highest in the service name. In this example, service #4 has the
most recent diagnostic tape.
System prompts for service number. In this example, choose service #4
since it contains the most recent version of the diagnostic media.
Verification 8–17