Installation guide

8.4 Verify Console Load Device Path
If your console load device is a CD server, check the Ethernet
adapter’s loopback path (see Section 8.4.1). If you are using
a tape, use the Z command and run RBDs on the tape drive
(see Section 8.4.2).
8.4.1 Verify Ethernet Adapter and Loopback
Check the Ethernet adapter’s self-test results. Open the
cabinet front door and check the green External Loopback
LED.
Figure 8–3: DEBNI/DEMNA LEDs
SELF-TEST OK LED
CONNECTOR
EDGE
msb-0134A-90
EXTERNAL
LOOPBACK LED
8–8 VAX 6000 Series Installation Guide