User guide

Removing blockages
WARNING: To reduce the risk of electric shock, turn the vacuum cleaner off and unplug from the electrical
outlet before performing maintenance/troubleshooting checks. Disconnect the hose from the vacuum
cleaner and remove any blockages found then reconnect the hose securely.
!
Replacing the brushbar belt
vax.co.uk
9
Maintenance (Keep your Vax as good as new)
Unscrew the 4 screws
from the base of the unit
using a crosshead
screwdriver.
Remove floor nozzle cover. Lift brushbar and remove
belt from the end of the
brushbar.
Squeeze tabs to remover
dial cover.
Pull dial towards you. Clean and remove any
debris from inside.
Remove lower hose and
check for blockages.
Vax U88-M9-B UG V1.0 [J150] [07.03.12]_User guide 12/03/2012 13:59 Page 9