User guide

27
applying power
Operator control module
Switch the Main Power Switch (see
FIGURE #91) to the ON position to apply power
to the Operator Control Module.
The Display will show:
The Display will retain this information for
approximately 3 seconds and then revert to the
HOME SCREEN shown in FIGURE #101.
Note: This screen indicates which level soft-
ware is installed in the Sorter’s memory.
xxxxx = part number of prom currently used
in control.
FIGURE #110
POWER--UP DISPLAY
DE LA RUE
MAIN EPROM
XXXXX
DISPLAY
XXXXX