User guide

8
thermal printer
Installation
Install (replace) the Paper Roll as follows:
Pull the Access Panel (FIGURE #97) forward
and lift the Keyboard. A self--contained bracket /
spring will retain it in position.
Tilt the Printer Mechanism forward, and remove
the old Paper Roll Core.
Install the new Paper Roll between the retainers
so that the paper feeds from the bottom of the
roll, as shown in FIGURE #98.
Push the top of the roll lock to open the roller
gap in the Printer.
Route the leading edge of the paper over the
top of the arched metal bracket and down into
the slot at the top of the Printer Mechanism.
Push the bottom of the Roll Lock to close the
roller gap in the Printer.
Turn the knurled knob at the right of the Printer
Mechanism to advance the paper.
Return the Printer Mechanism to its upright
position and lower the the Keyboard, while feed-
ing the leading edge of the paper through the
Cutoff Slot.
FIGURE #98
PRINTER PAPER
(RETAINER BRACKET NOT SHOWN FOR CLARITY)
Paper Roll
Roll Retainer
Printer
Mechanism
Keyboard
Cutoff Slot
Lock / Knurled Knob
Note: The Paper Roll must be installed so that
the feed is as shown to ensure proper printing.
Arched Metal Bracket