User guide

---
8
Maintenance (Keep your Vax as good as new)
Vax Careline: (UK) 0844 412 8455
(ROI) 1-800 928 308
Removing blockages from the brushbar
WARNING: To reduce the risk of electric shock, turn the vacuum cleaner off and unplug from
the electrical outlet before performing maintenance/troubleshooting checks.
Disconnect the hose from the vacuum cleaner and remove any blockages found then reconnect
the hose securely.
Resetting jammed brushbar
A red flashing light will indicate a jammed brushbar. To reset press the button on the side of your vacuum.
Removing debris from the brushbar
If the light continues to flash red after resetting, the brushbar may still be blocked. Using a pair of
scissors, cut through any threads or hairs caught around the brushbar. To access brushbar:
Press the brushbar reset button again to ensure the blockage is fully cleared.
IMPORTANT: for your safety, never try to access/replace brushbar drive belt. If problem
persists please call our Careline: 0844 412 8455
!
Red light Green light
!
Removing blockages from the TurboTool (some models only)
Turn TurboTool over.
Slide off the locking ring.
Pivot lower housing and
remove clog.
To re-assemble,
ensure that the tabs
are aligned and pivot
the lower housing
closed. Slip the locking
ring into the groove at
the neck of the
TurboTool to complete
reassembly.
Locking
ring
Tabs
U89-MAF2 Mach Air Force 2 Series UG v1.0.qxd:User guide 18/2/11 16:16 Page 8