User`s guide

7.4.1 MENU Mode Evocation
MENU mode is invoked after the "base" system is fully prepared. Prepare the "base" system by
performing the following steps:
1. Insert TU58 tape cartridge #34, labeled VAX 11725/730 CONSOLE, into the TU58 tape
drive
1.
2. Insert TU58 tape cartridge #36, labeled 11725/730 MICRODIAG, into the TU58 tape drive O.
3. Insert the diagnostic distribution disk cartridge into the disk drive. Depress the LOAD button
on the disk drive to place it on-line. The disk drive mayor may not be WRITE PROTECTed.
NOTE
For the V AX-l 1/730 SBB system with no RA60
disk drive (TU80 present), the CRDs will execute
from the system disk drive (if the CRDs were copied
to that disk drive).
4. Ensure that the system disk drive contains the system disk and is on-line. The system disk may
or may not be WRITE PROTECTed.
NOTE
CRD
MENU mode performs nondestructive disk
testing on V
AX/VMS disk cartridges. If the disk
which is inserted into the disk drive is formatted
under systems
other than V AX/VMS, WRITE
PROTECT the disk to protect the data.
5. Invoke MENU by one of the following methods:
Console
I/O Mode Method
a. Obtain the console prompt, »>, as described in Chapter 2.
b. Type T /M in response to the console prompt as shown below:
»)T/M<CR)
NOTE
When the command »>T/M is typed there is a
time span of approximately 1.5 minutes before the
first message is printed on the console terminal.
Diagnostic Supervisor Method
a. Obtain the diagnostic supervisor prompt DS> as described in Chapter 5.
7-10