User`s guide

7.3.1 AUTO Mode Evocation
AUTO mode is invoked after system preparation is performed. The system is prepared for testing and
AUTO mode is invoked by performing the following procedures:
1. Insert TU58 tape cartridge #34, labeled VAX 11725/730 CONSOLE, into TU58 tape drive 1.
2. Insert TU58 tape cartridge #36, labeled 11725/730 MICRODIAG, into TU58 tape drive o.
3. Insert the diagnostic distribution disk cartridge into the- user disk drive. Depress the LOAD
button on the disk drive to place it on-line. The disk drive mayor may not be WRITE
PROTECTed.
NOTE
For the
VAX-ll/730 SBB system with no RA60
disk drive
(TU80 present), CRDs will execute from
the system disk drive (if CRDs were copied to that
disk drive).
4. Ensure that the system disk drive contains the system disk and is on-line. The system disk may
or may not be WRITE
PROTECTed.
NOTE
CRD
AUTO mode performs nondestructive disk
testing on
V AX/VMS disk cartridges. If the disk
which
is inserted into the disk drive is formatted
under systems other than
VAX/VMS, WRITE
PROTECT the disk to protect that data.
5. Obtain the console prompt, »>, as described in Chapter 2.
NOTE
After the console prints VERSION xx.yy, a
CTRL/C may be typed since all microcode needed
to execute CRDs is loaded.
6. Invoke AUTO mode by typing T to the console prompt as shown below:
»>T <CR>
NOTE
When the command,
»>T, is typed, there is a time
span
of approximately 35 seconds before the first
message is printed on the console terminal.
7-4