User`s guide

VAX-ll/730 SBB System
1. Tests the CPU, memory and FPA with microdiagnostics.
2. Tests the CPU with level 4 diagnostics.
3. Boots the diagnostic supervisor from the disk drive (0 or 1).
4. Tests the DMF32 and the UDA50 disk drive with macrodiagnostics.
Once AUTO mode is invoked, device testing is completed without user intervention in approximately 15
minutes. An exception to this would be when the system is improperly set up. In this instance, the AUTO
mode program displays an informational message and halts (Example 7-1). The operator has a chance to
properly prepare the system, and resume execution of the AUTO mode by typing a <CR>.
Upon successfully completion of AUTO mode CRD enters MENU mode (see Section 7.4).
***
VERSION
BEGIN VAX-11/730,725 AUTO TEST ***
x.x RUN TIME APPROXIMATELY 15:00 MINUTES
CPU PART
MEMORY
CPU PART 2
FPA
RB730
TESTING STARTED
TESTING STARTED
TESTING STARTED
TESTING STARTED
TESTING STARTED
RL02 PART 1 DQA1 TESTING STARTED
RUN TIME
RUN TIME
RUN TIME
RUN TIME
RUN TIME
RUN TIME
** PROPER SETUP REQUIRED - TYPE <CR> TO
CONTINUE
3:30
1 : 30
0:45
1 : 30
0:45
0: 15
**
** CHECK FOR RL02 DIAGNOSTIC PACK 'CRDPACK' **
** INSERTED AND SPINNING IN DRIVE DQA1: **
**
IF SETUP CORRECT, POSSIBLE RL02 DRIVE
PROBLEM
CPU PART 3 TESTING STARTED
R80 DQAO TESTING STARTED
RL02 PART 2 DQA1 TESTING STARTED
DMF32S XGAO TESTING STARTED
DMF32A TXAO-TXA7 TESTING STARTED
DMF32P
DMF32P
LCAO TESTING STARTED
LCAO TESTING STARTED
AUTO TEST COMPLETE - NO ERRORS
RUN TIME
RUN TIME
RUN TIME
RUN TIME
RUN TIME
RUN TIME
RUN RIME
**** END OF VAX-11/730,725 AUTO TEST
****
MENU MODE is entered at this pOint.
**
4:00
0:30
0:30
1 : 00
0:30
0: 15
1 : 00
Example 7-1 Printout of an AUTO Mode Testing Sequence
on a
RL02/R80-Configured System in Which the System
Was Improperly
Set Up
7-3
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED
PASSED