User`s guide

CHAPTER 8
8.1
8.2
8.2.1
8.2.2
APPENDIX A
APPENDIX B
Figure No.
1-1
2-1
3-1
3-2
3-3
Table No.
1-1
2-1
2-2
2-3
2-4
2-5
2-6
2-7
3-1
4-1
4-2
4-3
BUILDING AND UPDATING THE SYSTEM DISK
DIAGNOSTIC AREA
INTRODUCTION .................................................................................................... 8-1
BUILDING AND UPDATING THE DIAGNOSTIC AREA ............................... 8-2
Building and Updating the Diagnostic Area with the COpy Command ........ 8-2
Building and Updating the Diagnostic Area with
DUCT ................................ 8-2
VAX-ll/730 INTERNAL PROCESSOR REGISTERS ....................................... A-I
MICRODIAGNOSTIC MONITOR COMMANDS ............................................... B-1
FIGURES
Title Page
VAX-II Diagnostic System User Documentation .................................................... I-I
Power-Up Sequence of Events .................................................................................. 2-5
Cold Start of Either the Operating System or the Diagnostic Supervisor ............... 3-2
Warm
Start of the Operating System ....................................................................... 3-7
Restart Parameter Block (RPB) ................................................................................ 3-8
TABLES
Title
Page
VAX-I
1/730 Related Documentation ...................................................................... 1-2
CPU Halt Codes and Halt Conditions ...................................................................... 2-2
Functions
of the Six-Position Keylock Switch .......................................................... 2-3
The Functions of the Three-Position AUTO/RESTART Switch ............................. 2-4
Functions
of the Front Panel State Indicator Lights ................................................. 2-4
Control Characters for the Console
I/O Mode ... .... ...... ... .... ...... ............. ..... .......... 2-10
EXAMINE and DEPOSIT Qualifiers and Definitions. .... ... .... ............ ......... ......... 2-12
The LOAD Qualifiers and Definitions ...... .....
... ...... ... .... ........ ... ........ .... ...... ... ......... 2-15
Parameters Loaded into the General Registers at BOOT ........................................ 3-5
ENKBx Microdiagnostic Group Sections ................................................................. 4-1
ENKCx Microdiagnostic Group Sections ................................................................. 4-2
MICMON Error Code List (Hex) ............................................................................ 4-6
v