User`s guide

6.1.1 Loading EVKAA from the TU58 Tape Cartridge
The level 4 diagnostic EVKAA is loaded and executed with the console command language as shown in
the following steps:
I. Insert the TU58 tape cartridge # 11, labeled VAX 11 HARDCORE INSTR, into the TU58
drive o.
2. At the console prompt, »>, type the following commands to load and execute EVKAA:
»)1
»)D/P/L FEOO 0
»)L/P/S:O DDO:EVKAA.EXE
»)
Initializes the CPU.
Zero memory location FEOO.
Loads the diagnostic into memory.
After EVKAA is loaded into memory, it is executed using the procedure in Section 6.1.3.
6.1.2 Loading and Executing EVKAA from the Disk Pack
EVKAA is loaded and executed from the disk pack as described in the following:
I. Boot the diagnostic supervisor from the disk pack as described in
Chapter 5.
2. When the DS> prompt is displayed, load EVKAA from the disk pack into memory by using
the
LOAD command:
DS)LoAD EVKAA
Loads the diagnostic into memory.
3. Exit from the diagnostic supervisor to the console I/O mode by typing the EXIT command:
DS)EXIT
?02 PC=0001A5D8
»)
6.1.3 Executing EVKAA
Terminates the diagnostic
supervisor.
Enters the console 110 mode.
After EVKAA is loaded into memory it is executed at memory location 200 with the following command:
»)S 200
! Executes the diagnostic program
! at memory location 200.
If EVKAA executes successfully, at the end of each 100 passes the console produces one line of the
printout shown below and rings the terminal bell.
EVKAA Vx.x PASS #nn DONE!
EVKAA Vx.x PASS #nn DONE!
EVKAA Vx.x PASS #nn DONE!
This program continues to execute and produce the above printout until a CTRL/P is typed. At that time
the system returns to the console
I/O mode and prints the console prompt, »>.
6-2