User`s guide
2.
Type A
TT
ACH
to the
COMMAND?
prompt to actually build the database in the diagnostic
supervisor.
3.
Type
EXIT
to the
COMMAND?
prompt to
-exit
the autosizer program. The autosizer prints the
completion message shown below (if
no
errors were encountered) on exiting.
It
then returns
console control to the diagnostic supervisor,
OS>.
COMMAND?
EXIT
........•..
End
of
run,
0
errors
detected,
pass
count
is
1,
time
is
dd-mmm-yyyy
HH:MM:SS
DS)
4. Select the devices to be tested. Then use the
RUN
command to load and execute the diagnostic
program.
See Chapters 4 and 5
of
the V
AX
Diagnostic
System
User's Guide for details on the diagnostic supervisor
commands.
5-10