User`s guide
If
EYKAA
executes successfuly,
at
the end
of
each
16
passes the console produces a printout as
shown below and rings the terminal bell.
EVKAA
Vn.n
PASS
#nn
DONE!
EVKAA
Vn.n
PASS
#nn
DONE!
EVKAA
Vn.n
PASS
#nn
DONE!
This program continues to execute
and
produce the above printout until a
CTRL/P
is
typed.
At
that
time the system returns to the console
I/O
mode and prints the console prompt,
»>.
If the level 4 diagnostic executes without error, the diagnostic supervisor
(ENSAA.EXE)
is
loaded from
TU58
#35
and
executed using the console
command
language. Then, the disk
subsystem diagnostic
is
loaded and executed.
3.
Remove
TU58
#7 from
TU58
tape drive
o.
4.
Insert
TU58
tape cartridge #35, labeled
11725/730
DIAG
SUPER,
into
TU58
tape drive
o.
5.
In response to the console prompt, type
the
following commands to load and execute the
diagnostic supervisor from the tape cartridge:
»>1
»>L/P/S:FEOO
DDO:ENSAA.EXE
»>S
10000
When the diagnostic supervisor starts, it prints the following message:
DIAGNOSTIC SUPERVISOR.
ZZ
ENSAA-x.x-xx
DD-MMM-YYYY
HH:MM:SS
DS>
6.
For the Y
AX-II
/730
system with the IDC disk controller, perform the following steps to define
the system hardware configuration and execute
ENRKA.
a. Use the A
TT
ACH
command
to define the hardware configuration as shown below:
DS>ATTACH
KA730
HUB
KAO
YES
03FF 12048
NO NO
DS>ATTACH
DW730
HUB
DWO
DS>ATTACH
RB730
DWO
DQA
DS>ATTACH
RL02
DQA
DQA1
either:
DS>ATTACH
RL02
DQA
DQAO
for the dual
RL02
system, or:
DS>ATTACH
R80
DQA
DQAO
for the
RL02/R80
system.
b.
Use the following select
command
to select the disk device for testing:
DS>SELECT
DQA1,DQAO
5-6