User`s guide

CHAPTER 4
4.1
4.2
4.3
4.4
CHAPTER 5
5.1
5.2
5.2.1
5.2.2
5.2.3
5.2.4
5.3
5.3.1
5.4
CHAPTER 6
6.1
6.1.1
6.1.2
6.1.3
6.2
CHAPTER 7
7.1
7.2
7.3
7.3.1
7.3.2
7.3.3
7.4
7.4.1
7.4.2
MICRODIAGNOSTICS
INTRODUCTION .................................................................................................... 4-1
LOADING THE MICMON ..................................................................................... 4-2
MICRODIAGNOSTIC MONITOR COMMANDS ............................................... 4-5
MICRODIAGNOSTIC ERRORS ............................................................................ 4-5
VAX-ll/730 DIAGNOSTIC SUPERVISOR AND LOAD PATH
INTRODUCTION .................................................................................................... 5-1
LOADING THE SUPERVISOR THROUGH THE PRIMARY LOAD
PATH ........................................................................................................................ 5-1
Loading the Supervisor Off-Line from the Diagnostic
Distribution Disk ............................................................................................... 5-2
Loading the Diagnostic Supervisor
Off-Line from the System
Disk .................................................................................................................... 5-2
Loading the Supervisor
On-Line from the Distribution Disk ........................... 5-3
Loading the Supervisor On-Line from the System Disk ................................... 5-4
LOADING THE DIAGNOSTIC SUPERVISOR THROUGH THE
SECONDARY LOAD PATH .................................................................................. 5-4
Executing Diagnostics for the Load Path .........................................................
5-5
DIAGNOSTIC SUPERVISOR COMMANDS ....................................................... 5-8
EXECUTING
THE LEVEL 4 DIAGNOSTIC PROGRAM
LOADING AND EXECUTING THE LEVEL 4 DIAGNOSTIC
PROGRAM
............................................................................................................... 6-1
Loading EVKAA from the TU58 Tape Cartridge .......................................... 6-2
Loading and Executing EVKAA from the Disk Pack ..................................... 6-2
Executing EVKAA ........................................................................................... 6-2
EVKAA
ERROR INTERPRETATION AND LOOP CONTROL ...................... 6-3
CUSTOMER RUNNABLE DIAGNOSTICS
INTRODUCTION
.................................................................................................. 7-1
CRD MINIMUM SYSTEM CONFIGURATION ................................................. 7-1
AUTO MODE ........................................................................................................... 7-2
AUTO Mode Evocation .................................................................................... 7-4
AUTO Mode Messages ..................................................................................... 7-5
A
UTO Mode Errors.......................................................................................... 7-8
MENU MODE .......................................................................................................... 7-9
MENU Mode Evocation ................................................................................. 7-10
ME NU Mode Errors ...................................................................................... 7-1 7
iv