User`s guide
5.2. t Loading the Supervisor Off-Line from the Diagnostic Distribution Disk
The diagnostic supervisor
is
loaded off-line from the diagnostic distribution disk by booting the supervisor
from
that
disk. To boot the diagnostic supervisor from the diagnostic distribution disk perform the
following procedures:
1.
Load the diagnostic distribution disk labeled VAX
725/730
CMPLT
DIAG
into the removable
media disk drive and place the drive
on
line (LOAD button in).
2.
In
response to the console prompt, type the following command to boot the supervisor:
»>B
Sx1
NOTE
When the command
»>B
Sxt
is
typed, approxi-
mately 1.75 minutes elapse before any messages
are
printed on the console terminal.
The console responds by printing a boot message and the diagnostic supervisor prompt
(DS»
as shown
in
Example 5-1. The DS> prompt indicates
that
the diagnostic supervisor
is
loaded and executing.
»>B
SQ1
»>@DD1:SQ1BOO.CMD
»>1
»>D/G/L
0 00A80003
»>D/G
1 3
»>D/G
2 3FB86
»>D/G
3 1
»>D/G
4 0
»>D/G
5
10
»>E
SP
G
OOOOOOOE
00000200
»>L/P/S:@
VMB.EXE
»)5
@
DIAGNOSTIC
SUPERVISOR.
ZZ-ENSAA-x.x-xxx
DD-MMM-YYYY
HH:MM:SS
DS)
Example
5-1
Console Printout
of
Booting the Diagnostic
Supervisor from the
RL02 Diagnostic Distribution Disk
5.2.2 Loading the Diagnostic Supervisor
Off-Line from the System Disk
The diagnostic supervisor
is
loaded off-line from the system disk by booting the supervisor from that disk.
To
boot the diagnostic supervisor from the system disk perform the following procedures:
1.
Place the system disk drive
on
line (LOAD button illuminated).
2.
In
response to the console prompt, type the following command to boot the diagnostic from the
system disk:
»>B
SxO
5-2