User`s guide

Method 1 loads the MICMON prior to loading the system microcode. Perform the procedures below:
1. Insert TU58 tape cartridge #36 (labeled 11725/730 MICRODIAG) into TU58 tape drive 1.
CAUTION
Make sure that the stabilizer foot is extended from
the bottom
of the system cabinet before the CPU
mounting box is extended.
2. Set the AUTO-RESTART/BOOT switch to the OFF position.
3. Turn the keyswitch to the LOCAL position.
The VAX-l
1/730 powers up and the CPU enters the microdiagnostic monitor (MICMON), causing the
console to produce a printout as shown in Example 4-1.
CONxyz
?40 FILE NOT FOUND DD1:CONSOL.EXE
?27
?27
CONTINUING
READ ERROR
CONTINUING
READ ERROR
CONTINUING
VER X.Y MMM.YY
MIC>
DOD:
DOD:
Example 4-1 Console Printout at Power-Up
as the CPU Enters MICMON
Method 2 loads the MICMON after the console microcode. Perform the following procedure:
1. Insert the TU58 tape cartridge #34 (labeled VAX 11725/730 CONSOLE) into TU58 tape
drive
1.
CAUTION
Make sure that the stabilizer foot is extended from
the bottom
of th~ system cabinet before the CPU
mounting box is extended.
2. Set the AUTO-RESTART/BOOT switch to the OFF position.
4-3