User`s guide

When the CPU enters the console mode, it prints on the console terminal:
• A question mark followed by a two-digit halt code (Table 2-1).
• The address contained in the program counter (PC).
•
The console prompt symbol, »>.
For example:
P ! CTRL/P typed at the console terminal
?02 PC=nnnnnnnn ! Halt code followed by the PC address
») ! Console prompt
2.2 FRONT PANEL CONTROLS AND INDICATORS
The front panel of the VAX-l 1/730 has two switches and four indicator lights. These switches, indicator
lights, and their functions are identified below.
2.2.1 Six-Position Keylock Switch
The six positions of keylock switch and the functions of each are shown in Table 2-2.
Table 2-2 Functions
of the Six-Position Keylock Switch
Position Function
OFF No power is applied to the CPU or to memory.
STD BY Power is applied to main memory, the WCS module and to the TUS8 tape
drives.
LOCAL Power is applied to the CPU and to memory allowing the CPU to respond to
console commands. The remote access port is disabled.
LOCAL/DISABLE The CPU does not respond to console commands, however the console terminal
functions as a user terminal. The remote access port
is disabled. The BOOT
position of the AUTO RESTART switch is ignored.
REMOTE/DISABLE The console terminal is disabled. The remote access port is enabled, allowing a
terminal connected to it to be used
as a user terminal. The CPU does not
respond to console commands from this remote terminal.
REMOTE The remote terminal functions as the console terminal. The console terminal is
disabled unless enabled by the remote terminal.
2-3