Installation guide

Console Commands 3-5
3.2 Build EEPROM
The build eeprom command is used to create a new EEPROM im-
age or to restore a corrupted EEPROM image.
Example 3-2 Build EEPROM Command
>>> build eeprom # Build EEPROM if invalid
# message is displayed.
Creating new EEPROM image
System Serial Number> GAO1234567 # If the EEPROM is
Module Serial Number> SG226LFH01 # corrupted, enter
# system serial number
# and module serial
# number, part number,
# and firmware revision.
Module Unified 2-5-2-4 Part Number> -E2040-AA. M06
Module Firmware Revision> 1.5
>>>
The build eeprom command syntax is:
bu[ild] ee[prom]
If you are restoring a corrupted EEPROM, you will be prompted to supply
the system serial number and module serial, part, and firmware revision
numbers. The build eeprom command may be required during a console
firmware upgrade. Before upgrading, you should refer to Table 2-3 and
use the show <envar> command (see Section 3.24) to display present en-
vironment variables values. After rebuilding, use the set <envar> com-
mand (see Section 3.18) to set the environment variables to their desired
values.
For more information:
Advanced Troubleshooting
Release Notes