User guide

Taking care of your machine Taking care of your machine
The clean water tank contains a washable lter. Clean this lter
when suction is low. Pull open the lter lid gently to remove the
lter for cleaning
Nozzle can be removed
for easy cleaning. Slide
the two nozzle release
latches outwards
Push both brush release
buttons and remove the
brush assembly. Brushes
can be rinsed under water
to remove debris (Max 40°C)
Remove nozzle by pulling
straight out and rinse under
running water (max. 40°C)
To replace brushes, align the
post with square hole on the
bottom of the machine. Push
brushes rmly at both ends
until it locks into place
Rinse under water to remove
debris (max. 40°C) and leave
for at least 24 hours or until
fully dry before replacing in
the machine
Remove any debris from
squeegee by wiping with
a damp cloth
To replace nozzle ensure
latches are in the out position,
insert nozzle into middle sec-
tion of base. While holding the
nozzle in place, slide latches
inward to lock into place
MAX
40˚C
MAX
40˚C
Make sure the lter screen is
wiped clean to remove any
dirt/debris
Place dry lter back into lid,
replace lid and press down
rmly until snapped in place
To replace the recovery tank, align
bottom of recovery tank behind
ledge and push rmly until clicks
into place
Cleaning the nozzle
Cleaning the brushes
Warning: Always remove the tanks before carrying out brush/nozzle maintenance.