User guide

Always switch OFF the steamer
when tting the microbre
cleaning pads.
WARNING
Using your machine Using your machine
To produce steam squeeze
the trigger in short bursts.
Don’t hold the trigger
continuously to prevent over
wetting carpet.
Move the steamer slowly
backwards and forwards
across the carpet paying
particular attention to high
trac areas. Squeeze/
release trigger as required.
To release the carpet
glider, place your foot on
clip and push down. Lift
steamer to remove.
Refreshing carpets
Place your foot on oor head
and pull handle backwards
to recline.
IMPORTANT: Never use the steamer without a cleaning pad attached to the oor head. Never leave the steamer on one spot
for an extended period of time or with a damp or wet microbre pad attached as this may damage the oor surface.
IMPORTANT: When using on carpets, always make sure the microbre cleaning pad is used and covers the oor head entirely
before using the carpet glider
Only use the carpet glider when refreshing carpets and turn the detergent dial to OFF
Place the microbre pad on
the oor white side facing
up. Place steamer onto pad
making sure the entire pad
covers the oor head.
To steam your oors with
detergent turn the dial to ON
and without detergent turn
the dial to OFF.
Plug into mains and twist
on/o control dial to ON.
The blue light will illuminate
to indicate power on. The
green light will illuminate
to indicate the steamer is
ready to use.
Place your foot onto the
oor head and pull handle
backwards to recline.
Using the steamer
Move the steamer slowly
backwards and forwards
across the oor paying
particular attention to high
trac areas. Squeeze
/release trigger as required.
To produce steam
squeeze the trigger in
short bursts. Don’t hold
the trigger continuously to
prevent over wetting oors.
Hold corner of pad down with
your foot and lift steamer
to peel away.
Plug into mains and twist on
/o control dial to ON.
Place the microbre pad on
the oor white side facing
up. Place steamer onto pad
making sure the entire pad
covers the oor head.
With microbre pad attached,
push steamer into front of
the carpet glider, then place
back of the oor head into the
clip. The carpet glider should
only be used when refreshing
carpets.
Turn the detergent dial to OFF
when refreshing carpets.