User guide

Push the main body down
into the oorhead until it
clicks into place.
Push the handle into main
body until it clicks into place.
Stand the steamer upright
by pushing the main body
forward to lock into position.
Assembling your steamer
Getting started Using your machine
PLEASE READ ‘LET’S TALK SAFETY’ AT THE BEGINNING BEFORE USE
Insert concentration nozzle
into the storage hook on the
back of handle.
Press the water tank release
buttons and pull the water
tank to remove.
Slide the water tank back into
the machine until it clicks
into place.
Pull the tab on the water tank
cap to open.
Fill the water tank with
260ml of water, replace the
cap and push rmly to close.
Twist the detergent tank
cap anti-clockwise and lift
to remove.
Pour 50ml of Vax detergent
and 150ml of water into the
detergent tank.
Press the release buttons
and pull the detergent
tank to remove.
IMPORTANT
• If you don’t want to use detergent on your ooring, turn detergent dial to OFF position.
• Always test on an inconspicuous area of ooring rst before using detergent.
• Don’t over ll the clean water/detergent tanks or exceed the maximum amount required.
• Don’t use the steamer without water in the water tank. Always top up with water in good time.
Before you Begin
WARNING
• The steamer and accessories get very hot during use, always allow them to cool down before handling.
• Always unplug and switch o the steamer when assembling.
• Always switch o the steamer before emptying the water tank or changing the cloths/accessories.
IMPORTANT
• Please refer to oor manufacturer’s care recommendations before use and test the steamer on a hidden area of ooring
to begin with.
• Test for colour fastness in a small hidden area of upholstery/fabric to check for colour removal before use.
• When using the steamer, basic safety precautions should always be observed.
• Don’t aim the steamer at people, animals, plants and electrical components or wires. Never touch the steam jet or oor head
from a short distance (there is a risk of scalding).
• The steamer is equipped with a thermostat and a thermal cut-out. If for any reason the steamer overheats it will switch o.
If this happens turn o and unplug the steamer, allow to cool for at least 2 to 4 hours and re-try.
Filling water tank
Insert tools into the back of
the steamer.
Replace the detergent tank
back into the steamer and
push until it clicks into place.
Replace the detergent
tank cap and twist
clockwise to close.
Filling detergent tank