Vax V-120 User Guide.qxd 9/10/07 12:43 Page 1 Vax careline 0870 6061248 Vax model number: V-120 www.vax.co.uk instruction manual Hard floor cleaner Please read carefully before using this cleaner. Always fully extend the mains cable before use. Retain for future reference.
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 2 www.vax.co.uk 1. Diagram V-120 1 2 3 HAR D FLO O R CLEANIN G SOL UTION 20 16 4 4 5 17 6 7 9 8 18 10 18 15 11 12 13 Fig.
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 3 Vax Careline 0870 606 1248 2. Safety Information FOR HOUSEHOLD USE ONLY. 19. Using improper voltage may result in damage to the motor and possible injury to the user. The correct voltage is listed on the rating label. When using the hard floor cleaner, basic safety precautions should always be observed, including the following: 20. To prevent dirty water from running into motor, do not hold the appliance upside-down or lay on its side.
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 4 www.vax.co.uk 3. Preparing the Cleaner While holding nozzle in place, slide latches inward to lock in place (Fig.3/4). Installing Brushed and Nozzle To install brushes, place handle in upright position. Tilt cleaner back so that it rests on the floor. Align post (A) on brush block with hole (B) on bottom of cleaner. Turn brushes slightly until post fits easily into hole (Fig.3/1). B Fig.
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 5 Vax Careline 0870 606 1248 Handle Release Pedal Step on pedal (A) to lower handle to operating position. Handle does not lock into a single position, but “floats” to allow convenient operation (Fig.3/7). The cleaner may also be lifted using the carrying handle (A) on the front of the cleaner (Fig.3/10). A Fig.3/10 A Fig.3/7 On/Off Switch Push switch (A) once to turn cleaner ON. Push switch again to turn cleaner OFF (Fig.3/8). A Fig.
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 6 www.vax.co.uk 4. Operation Your FloorMate cleaner can be used to both vacuum dry debris and wet clean non-carpeted floor surfaces such as vinyl, tile and sealed wood. It is not intended for use on carpet or rugs. CAUTION: To prevent damage to wood floors, follow the flooring manufacturer’s cleaning recommendations. ! Filling the Solution (Upper) Tank The solution tank holds solution and water that is to be dispersed onto the surface being cleaned.
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 7 Vax Careline 0870 606 1248 Check for worn spots or joint separations before using, as these conditions could lead to damaged flooring when using water to clean floor. Pour cleaning solution into tank (A). Fill tank to fill line (B) with warm water (Max 40°C) (Fig.4/6). A Fig.4/9 B Emptying the Recovery (Lower) Tank Fig.4/6 If rubber ring (A) on cap has become dislodged, reposition it with uneven side against ledge (B) as shown (Fig.4/7).
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 8 www.vax.co.uk 5. How to Clean A Recommended Cleaning Sequence Use your Vax FloorMate to: • Dry Vacuum to remove loose dirt, hair and debris. • Wet Clean the floor surface. The brushes will provide light agitation to help loosen dirt. • Wet Pickup reduces drying time of the floor surface. The Mode selector dial turns the brushes on and off as described in section 4.
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 9 Vax Careline 0870 606 1248 6. Maintenance Cleaning the Filters The tank lid contains a washable, reusable filter. Clean this filter when suction is low or reduced. A Turn cleaner off and disconnect from electrical outlet. Remove recovery tank and lid as described in Section 4. Remove filter lid (A), then remove filter (B) (Fig.6/1). Fig.6/3 B Reposition pleated filter in lid. Replace lid onto recovery tank, pressing down firmly until snapped in place.
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 10 www.vax.co.uk The brushes can be washed with a mild detergent and rinsed. Do not use a solvent based detergent. To replace brushes, align post (A) on brush block with hole (B) on bottom of cleaner. Turn brushes slightly until post fits easily into hole. Press brush assembly firmly to snap into place (Fig.6/9). B Fig.6/6 Rinse nozzle under running water. Remove debris from squeegee (A) and wipe with a damp cloth (Fig.6/7). A Fig.
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 11 Vax Careline 0870 606 1248 7. Troubleshooting PROBLEM: Cleaner does not pick up dirty solution. WARNING: To reduce the risk of personal injury, ! unplug the vacuum cleaner before performing maintenance or troubleshooting checks. Solution: Set mode selector switch to PICKUP. PROBLEM: Cleaner won't run Solution: Ensure that the dirty water tank is correctly installed. Cause: No electricity in the electrical outlet.
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 12 www.vax.co.uk 8. UK Service & Help 9. Technical Specification Vax Care 0870 6061248 Voltage: Capacity: Monday-Friday 9.00am to 5.00pm. An answerphone is available outside of these hours. Any queries or concerns about using the Vax, call the Vax Careline. Calls are charged at the UK national rate. Please make a note of the serial number and model number of the carpet cleaner before calling. There are over 400 approved Vax Service Agents in the UK.
Vax V-120 User Guide.
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 14 www.vax.co.
Vax V-120 User Guide.
Vax V-120 User Guide.qxd 9/10/07 12:43 Page 16 --- EEC STATEMENT OF COMPLIANCE Manufacturer/EEC importer: Vax Limited, hereby on our own responsibility, declare that the V-120 Floormate is manufactured in compliance with the following Directives: Safety: 2006/95/EC Low Voltage Directive EMC: 2004/108/EC Electromagnetic Compatibility Directive Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
