Instruction manual

7
Accessories/Dirt Container & Filter: Removal & Replacement/Rotating Brushbar: Removal & Replacement
Dusting Brush
The dusting brush is used for furniture, venetian
blinds, books, lamp shades and shelves.
6. Dirt Container & Filter:
Removal & Replacement
WARNING: To reduce the risk of injury from
moving parts, unplug before servicing.
NOTE: Unplug the cleaner before changing filter.
NOTE: For best performance, replace filters annually.
1. Press the latch above the dirt container and
remove the dirt container from the vacuum
cleaner (Fig.6/1).
2. Remove the dirt container lid (Fig.6/2).
3. Hold the dirt container and grasp the top of filter.
Twist and pull the filter up and out (Fig.6/3).
4. Empty the dirt container completely (Fig.6/4).
5. Each time the dirt container is emptied, the filter
should be cleaned. Tap the filter firmly against the
inside of a rubbish bin until the dirt stops falling
from the filter (Fig.6/5).
6. Return the filter to the dirt container. Push the filter
into place to prevent dirt leakage. Return the dirt
container to the cleaner (Fig.6/6).
7. Rotating Brushbar:
Removal & Replacement
TOOL REQUIRED: Phillips screwdriver.
WARNING: To reduce the risk of injury from
moving parts, unplug the cleaner before changing
the belt or the rotating brushbar.
To Remove the Belt
1. Lay the cleaner flat and turn it over to expose
the nozzle base. The base should lay flat and
face upwards. To remove the nozzle guard, use
a Phillips screwdriver to remove the three (3)
screws. The arrows below show the location of
the screws (Fig.7/1).
Fig.6/1
Fig.6/2
Fig.6/3
Fig.6/4
Fig.6/6
Fig.7/1
Fig.6/5
Vax V-041/2 9th.qxd 2/23/05 12:34 PM Page 7