Instruction manual

How to Operate/Accessories
6
On/off Pedal
Plug the cord into the electrical outlet. Turn the
cleaner on by pressing the foot pedal located on the
back left side of the vacuum cleaner (Fig.4/3).
Handle Release Pedal
To release the handle, push the handle release pedal
located on the lower left side of the cleaner (Fig.4/4).
Floor/Carpet Cleaning
Move the handle and adjust it to the desired position
for (A) storing the upright or (B) operating the vacuum
cleaner. De-press the handle release pedal again (C)
to clean under furniture (Fig.4/5).
5. Accessories
1. The vacuum cleaner must be in the upright
position to raise the brushbar (Fig.5/1).
2. Remove the hose from the tool caddy (Fig.5/2).
3. Choose any of the on-board accessories or use
the hose alone. Simply push the attachment firmly
on to the end of the extension tube or hose
handle. To remove the tool, twist and pull apart
gently (Fig.5/3).
Extension Tube
If additional length is needed, use the extension tube
and/or crevice tool. Pull crevice tool out of the
extension tube. Use the extension tube and crevice
tool together or separately (Fig.5/4).
TurboTool
™
(V-041 only)
The TurboTool
™
fits on the end of the telescopic tubes
or onto the end of the hose. Perfect for cleaning stairs
and upholstery. The TurboTool
™
should be pulled
backwards for optimum cleaning (Fig.5/5).
Carry Handle
Use the carry handle on the dirt container to move
the vacuum cleaner from room to room (Fig.5/6).
NOTE: Verify that the dirt container is secured in place
BEFORE lifting the cleaner.
Crevice Tool
Use the crevice tool for radiators, crevices, corners,
baseboards and between cushions.
Fig.4/3
Fig.4/4
Fig.4/5
Fig.5/1
Fig.5/2
Fig.5/3
Fig.5/4
Fig.5/5
Fig.5/6
A
B
C
Vax V-041/2 9th.qxd 2/23/05 12:34 PM Page 6